首页 管式反应器论文:有机废水管式电反应器的流动和传质数值模拟

管式反应器论文:有机废水管式电反应器的流动和传质数值模拟

举报
开通vip

管式反应器论文:有机废水管式电反应器的流动和传质数值模拟管式反应器论文:有机废水管式电反应器的流动和传质数值模拟 管式反应器论文:有机废水管式电反应器的流动和传质数值模拟 【中文摘要】管式电反应器是电化学处理有机废水的一种重要反应器,管内流场及传质研究是阐明此反应器宏观反应动力学和反应器设计的关键。计算流体力学(CFD)结合了数值模拟技术与流体力学等学科,是一种有效研究流体流动和反应的方法。本文采用FLUENT软件,对管式电反应器处理有机废水的流动和传质进行了数值模拟,考察速度标量场和矢量场的流体速度分布细节,观察到了漩涡和回流的生成,反应区内液相主体速度分布均匀,...

管式反应器论文:有机废水管式电反应器的流动和传质数值模拟
管式反应器论文:有机废水管式电反应器的流动和传质数值模拟 管式反应器论文:有机废水管式电反应器的流动和传质数值模拟 【中文摘要】管式电反应器是电化学处理有机废水的一种重要反应器,管内流场及传质研究是阐明此反应器宏观反应动力学和反应器设计的关键。计算流体力学(CFD)结合了数值模拟技术与流体力学等学科,是一种有效研究流体流动和反应的方法。本文采用FLUENT软件,对管式电反应器处理有机废水的流动和传质进行了数值模拟,考察速度标量场和矢量场的流体速度分布细节,观察到了漩涡和回流的生成,反应区内液相主体速度分布均匀,速度梯度主要集中在阳极 关于同志近三年现实表现材料材料类招标技术评分表图表与交易pdf视力表打印pdf用图表说话 pdf 面;从湍流密度角度,分析了反应器湍流密度详图,认为反应器液相主体内的混合是充分的,传质阻力主要集中在阳极表面。模拟得到反应器的停留时间数据,并进行了评估,停留时间的结果说明,实际停留时间为9.47s,小于14.75s的理论停留时间。对反应器内传质的细节进行了模拟和分析,建立了传质模型,根据相应的工况确定了传质模拟的条件。成功的得到了总体传质准数关系Sh=0.127Re0.67Sc1/3;局部传质能力沿轴向变化的情况是首端最高,逐渐下降至稳定,到末端传质能力部分上升;首次构建了后处理变量-极限电流密度,模拟显示阳极表面的极限电流密度分布极度不均。对反应器的进口设计进行优化后,以之前的工作为基础,对新的结构的反应器进行了模拟和比较,优化后的反应器的传质能力明显增高,传质施伍德数从202-431上升到1228-3143。 【英文摘要】Tubular electrochemical reactor is an important kind of reactors for organic wastewater treatment. Computational fluid dynamics (CFD) is a new subject combining the numerical simulation and Fluid mechanics. The fluid flow and reaction can be studied by the technology effectively with the help of computers.This study tried to model a tubular electrochemical reactor and characterize the flow and mass transfer inside the reactor using a CFD software-FLUENT. The simulation obtained the velocity field, the inside velocity distribution, the velocity vector field. The generation of eddy and circumfluence were observed; the distribution of velocity is uniform; the velocity gradient mainly existed on the surface of the anode. With the tool of the turbulent intensity, the diagram of the turbulence inside the reactor was showed. It indicated the level of the commixture was high in the bulk of liquor inside the reactor. The residence time distribution obtained by the simulation was evaluated; the result (9.47s) had a big difference with ideal value (14.75s). The details of mass transfer in the reactor were simulated and analyzed. The mass transfer model was made. According to the related operation conditions, the boundary conditions and the initial conditions were determined. The mass-transfer dimensionless equation (Sh=0.127Re0.67Sc1/3) was obtained, and the distribution of the local sherwood number along the anode axis showed the mass transfer ability was highest in the first Part of the compartment, and then decreased to a convergence value, at the last had a small jump up to a higher value. Post-processing variable (limited current density) was developed for the first time. The elaborate diagram of the limited current density over the surface of the anode showed the distribution was uneven very much. Two other kinds of tubular reactor were offered. Based on the prior work, the simulation for the two other kinds of tubular reactor was executed. The results were compared and showed the mass transfer rate increased highly, Sherwood number raised from 202-431 to 1228-3143. 【关键词】管式反应器 电催化氧化 计算流体力学(CFD) 湍流模 型 FLUENT 传质系数 极限电流密度 【备注】索购全文在线加好友:1.3.9.9.3.8848 同时提供论文写作一对一指导和论文发表委托服务 【英文关键词】tubular reactor electrocatalytic Oxidation computational fluid dynamics (CFD) turbulent model FLUENT mass transfer coefficient limited current density 【目录】有机废水管式电反应器的流动和传质数值模拟 摘要 4-6 ABSTRACT 6-7 第一章 绪论 12-22 1.1 概述 12 1.2 电化学技术原理 12-13 1.3 管式电催化氧化反应器研究进展 13-18 1.3.1 管式电反应器的结构和特点 13-15 1.3.2 管式电化学反应器的研究现状 15-16 1.3.3 管式电反应器的宏观动力学反应模型研究 16-18 1.4 CFD 技术在反应器优化设计中的应用 18-21 1.5 本文的研究意义及内容 21-22 第二章 数值模拟的计算模型选取 22-38 2.1 CFD 模拟 22-35 2.1.1 控制方程 23-25 2.1.2 湍流模型 25-31 2.1.3 网格划分 31 2.1.4 数值计算方法 31-35 2.2 FLUENT 软件 35-37 2.3 本章小结 37-38 第三章 反应器中流场的数值模拟 38-52 3.1 实验装置数值模型的建立 38-40 3.2 初始和边界条件 40-41 3.3 模拟结果与分析 41-51 3.3.1 速度场 43-46 3.3.2 湍流密度分布 46-47 3.3.3 停留时间 47-51 3.3 本章小结 51-52 第四章 反应器传质的数值模拟 52-65 4.1 传质模型的构建 52-53 4.2 传质模拟 53-59 4.2.1 传质模拟条件 53-54 4.2.2 总体传质系数 54-56 4.2.3 局部传质系数沿轴向的分布 56-58 4.2.4 电流密度分布 58-59 4.3 不同进口设计的反应器的比较 59-64 4.3.1 径向进口设计 60-61 4.3.2 切向进口设计 61-64 4.4 本章小结 64-65 第五章 结论和展望 65-67 5.1 结论 65-66 5.2 展望 66-67 参考文献 67-73 致谢 73-74 攻读学位期间发表的学术论文目录 74
本文档为【管式反应器论文:有机废水管式电反应器的流动和传质数值模拟】,请使用软件OFFICE或WPS软件打开。作品中的文字与图均可以修改和编辑, 图片更改请在作品中右键图片并更换,文字修改请直接点击文字进行修改,也可以新增和删除文档中的内容。
该文档来自用户分享,如有侵权行为请发邮件ishare@vip.sina.com联系网站客服,我们会及时删除。
[版权声明] 本站所有资料为用户分享产生,若发现您的权利被侵害,请联系客服邮件isharekefu@iask.cn,我们尽快处理。
本作品所展示的图片、画像、字体、音乐的版权可能需版权方额外授权,请谨慎使用。
网站提供的党政主题相关内容(国旗、国徽、党徽..)目的在于配合国家政策宣传,仅限个人学习分享使用,禁止用于任何广告和商用目的。
下载需要: 免费 已有0 人下载
最新资料
资料动态
专题动态
is_594905
暂无简介~
格式:doc
大小:19KB
软件:Word
页数:0
分类:生活休闲
上传时间:2017-09-26
浏览量:22