PAGE/NUMPAGES迈普交换机配置1、迈普设备配置基本命令用户名密码为:adminadminSwitch>enable//进入普通用户模式-只能看看Switch#configterminal//进入全局配置模式Switch(config)#vlan70//新建vlan70Switch(config-If-Vlan70)#nameguanli//将vlan70命名为guanliSwitch(config-If-Vlan70)#ipaddress172.17.202.21255.255.255.0//配置交换机管理地址Switch(config-If-Vlan70)#noshutdownSwitch(config-If-Vlan70)#exitSwitch(config)#iproute-static0.0.0.00.0.0.0172.17.202.1//配置交换机路由Switch(Config)#vlan338,440//新建vlan338,440Switch(config)#intethernet0/0/1//进入端口Switch(Config-Ethernet-0/0/1)#noshutdown//打开端口Switch(Config-Ethernet-0/0/1)#switchportmodeaccess//将端口定义为access口Switch(Config-Ethernet-0/0/1)#switchportaccessvlan388//将vlan338加入该端口Switch(Config-Ethernet-0/0/1)#exit//退出Switch(Config)#intethernet0/0/12-19;intethernet0/0/20//进入端口组Switch(Config-Port-Range)#switchportmodeaccess//将端口组定义为access口Switch(Config-Port-Range)#switchportaccessvlan440//将vlan440加入该端口组Switch(Config-Port-Range)#exit//退出Switch(Config)#intethernet0/0/21//进入端口Switch(Config-Ethernet-0/0/21)#switchportmodetrunk//将端口定义为trunk口Switch(Config-Ethernet-0/0/21)#switchporttrunkaaowedvlan70;338;440//该端口允许Vlan70,338,440通过Switch(Config-Ethernet-0/0/21)exit//退出0/0/21端口Switch(Config)#exit//退出.Switch#write//保存2、迈普设备故障处理基本命令1)查看交换机端口状态2)查看交换机端口描述3)查询mac地址4)修改交换机配置打开端口noshutdown关闭端口noshutdown迈普路由器配置与维护enable普通用户模式只能看看特权用户模式:filesystem文件系统模式configure全局配置模式----interface接口配置模式router***路由配置模式ipsccess-list访问列
表
关于同志近三年现实表现材料材料类招标技术评分表图表与交易pdf视力表打印pdf用图表说话 pdf
配置模式voice-port语音口配置模式dial-peer拨号端口配置模式系统配置温馨提示:最好仔细阅读后才下载使用,万分感谢!